EFFECTRODE AT-1A ATOMIC POWER SUPPLY

EFFECTRODE AT-1A ATOMIC POWER SUPPLY

Disponibile
€429.00 Tax included
Quantity

EFFAT2

The mighty Atomic™Isolated Power Supply was developed to meet the high power requirements of Effectrode tube effects pedals. Includes a unique ‘soft-start’ voltage capability, which eliminates tube heater filament flash and thus extends the life of the tubes.

Supplied with country-appropriate IEC power cable and four DC power leads.

MANUAL

FEATURES

  • Delivers a massive 6 amps at 12 Volts D.C. output for powering up to 4 vacuum tube effects
  • a unique ‘soft-start’ voltage capability , which eliminates tube heater filament flash and thus extends the life of the tubes.
  • Incredibly clean smoothed and regulated studio quality power supply
  • Supplied with country-appropriate IEC power cable and four DC power leads
  • Includes pedal board mounting brackets
  • Operates anywhere in the world from 110-250VAC. No more step up or step down transformers.
  • Solid diecast aluminium case
  • Fully isolated outlets completely eliminate earth loop hum
  • Short circuit/overload protection protects your tube pedals from damage should they inadvertently be connected reverse polarity (some day all power supplies will be made like this!).
  • One of the outputs can be configured to power 9V centre negative pedals (see note below)

COMPATABILITY LIST

The Atomic Power Supply is compatible with all Effectrode pedals (miniature and subminiature). It has also been tested with the following pedals by other manufacturers:
Empress Super Delay (12V center +ve)
Redwitch Titan Delay
Providence Chrono Delay (12V center -ve)
Kinglsey Bard (9V)
Vertex Axis Wah (9V)
Chicago Iron Octavian

EFFAT2

Data sheet

Power Supply Type
Multi Outputs
New
Comments (0)

Related products